Brake Disc - V8 S/C 5.0L Petrol (G2264155): Removal
WARNING:
Do not use compressed air to clean brake components. Dust from friction materials can be harmful if inhaled.
CAUTION:
- Take care not to contaminate the brake pad friction materials or the brake discs.
- Brake discs must be renewed in axle sets.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- This procedure contains illustrations for left side components, right side components are similar.
- If this component is being renewed because of a customer complaint, make sure to follow the brake system Diagnosis and Testing procedure.
Refer to: BRAKE SYSTEM .
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
- Remove the wheel and tire assembly.
Refer to: WHEEL AND TIRE - V8 S/C 5.0L PETROL .
-
NOTE: The brake pad wear sensor is installed on the left side only.
- Release the brake pad wear sensor.
- Release the 2 grommets.
-
CAUTION: Make sure that the brake hose does not support the full weight of the brake caliper assembly.
- Remove and discard the 2 bolts.
- Use a suitable cable tie to hold the brake caliper.
- Remove and discard the bolt.
- Remove the brake disc.