Rear Stabilizer Bar (G2187515): Installation

WARNING:
- Bolts must be tightened with vehicle at normal ride height.
- Make sure that new bolts are installed.
NOTE: Do not fully tighten at this stage.
- Install the rear stabilizer bar.
- Install the 4 bolts.
  Renew Part: Rear stabilizer bar to subframe bolts Quantity: 4 .
WARNING: Make sure that new nuts are installed.

CAUTION: Use an Allen key to prevent the ball joint rotating while installing the nut.
- Install the 2 rear stabilizer bar link.
- Install and tighten the 2 nuts.
  Renew Part: Stabilizer bar link upper nut Quantity: 2 .
  
  Torque : 70 Nm
Install the rear silencer.
Refer to: REAR SILENCER - EXHAUST SYSTEM - INGENIUM I4 2.0L DIESEL..
Install the rear wheel and tire assembly.
Refer to: WHEEL AND TIRE .
Lower the vehicle.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Tighten the 4 bolts.

Torque : 70 Nm