LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> E-Pace SE >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- E-Pace/X540 >> Vehicle Dynamic Suspension (G1941813) >> Removal And Installation >> Front Suspension Height Sensor (G2422509) >> Installation

Front Suspension Height Sensor (G2422509): Installation

  1. NOTE: Only do this step if previously removed.
    • Install the suspension height sensor to the bracket.
    • Install and tighten the 2 bolts.

      Torque  : 3 Nm 

    • Install the suspension height sensor to the vehicle.
    • Install and tighten the bolt.

      Torque  : 9 Nm 

  3. Connect the suspension height sensor link.
  4. Connect the electrical connector.
  5. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD .

  6. Using the Jaguar Land Rover (JLR) approved diagnostic equipment, calibrate the suspension ride height.

    Refer to: RIDE HEIGHT ADJUSTMENTS .

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals