LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2021 >> E-Pace SE >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Vehicle Dynamic Suspension -- E-Pace/X540 >> Vehicle Dynamic Suspension (G1941813) >> Removal And Installation >> Chassis Control Module (G2187522) >> Installation

Chassis Control Module (G2187522): Installation

    • Install the Chassis Control Module (CHCM).
    • Install and tighten the 3 nuts.

      Torque  : 7 Nm 

    • Install the wiring harness clip.
    • Connect the 4 electrical connectors.
  2. Install the left loadspace trim panel.

    Refer to: LOADSPACE TRIM PANEL .

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  4. If a new component has been installed, configure using Jaguar Land Rover approved diagnostic equipment.

    General Equipment: Jaguar Land Rover approved diagnostic equipment 

scientia non olet · About LEMON Manuals