Air Suspension - Manual Control Procedure - SPORTBRAKE (G1566158): Adjustment
CAUTION:
- Make sure the vehicle is in a clear working area.
- This procedure is required to maintain correct air suspension performance.
- Connect the Jaguar Land Rover approved battery support unit.
- Connect the Jaguar Land Rover approved diagnostic equipment to the vehicle and begin a new session.
- Follow the Jaguar Land Rover approved diagnostic equipment prompts.
-
- Select 'ECU Diagnostics'
- Select 'Chassis Control module (CHCM)'.
- Select 'ECU Functions'
- Select 'Ride level control module diagnostic interface'
- Follow all on-screen instructions to complete the task.
-
NOTE: Using the relevant on screen sliders/buttons, follow the process below:
Open the exhaust valve.
- Open the relevant corner valve.
- Turn the air compressor ON.
- Close the exhaust valve.
- Monitor the pressure on the diagnostic tool until 300 Kpa is reached.
- Turn the air compressor OFF.
- Close the corner valve.
- Check the rear air springs are correctly located into the body and lower arm.
- The vehicle can now be lowered on the wheels.
- When all of the tasks are complete, exit the session.
- Disconnect the Jaguar Land Rover approved diagnostic equipment and the Jaguar Land Rover approved battery support unit.