LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Starting System - V6 S/C 3.0L Petrol -- XF/(X260)) >> Starting System - V6 S/C 3.0L Petrol >> Removal And Installation >> Starter Motor >> Installation

Starter Motor : Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the starter motor.

    Torque  : 48 Nm 

  2. Install the lower starter motor bolt.

    Torque  : 48 Nm 

  3. Install the heatshield.

    Torque  : 6 Nm 

  4. Connect the electrical connector.

    Torque  : 7 Nm 

  5. Connect the electrical connector.

    Torque  : 12 Nm 

  6. Secure the clips.
  7. Install the right catalytic converter.

    Refer to: RIGHT CATALYTIC CONVERTER - RWD .

  8. Install the undershield.

    Refer to: ENGINE UNDERSHIELD .

  9. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

scientia non olet · About LEMON Manuals