Rear Silencer - Standard Wheelbase (G1818086): Removal

WARNING: This page is about a different variant/trim than selected.

WARNING: Observe due care when working near a hot exhaust system.

NOTE:

Right illustration shown, left is similar
This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the exhaust mounting.

Torque : 55 Nm
CAUTION: Make sure that a new bolt is installed.

NOTE: Do not disassemble further if the component is removed for access only.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the exhaust Noise Vibration and Harshness (NVH) mass damper.

Renew Part: Mass damper bolt Quantity: 1 .

Torque : 22 Nm