Ignition Coil-On-Plug : Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Before disconnecting or removing the components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
- Some variation in the illustrations may occur, but the essential information is always correct.
- Some components shown removed for clarity.
- Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
- Remove the engine cover.
Refer to: ENGINE COVER - V6 S/C 3.0L PETROL
-
CAUTION: To prevent contamination, make sure to install the oil filler cap after removing the sound proofing pad.