Valves (G1851894): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: Removal steps in this procedure may contain installation details.

Disconnect the battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
WARNING: Make sure to support the vehicle with axle stands.

Raise and support the vehicle.
Refer to: LEFT CYLINDER HEAD (G1853106)
Refer to: LEFT CYLINDER HEAD (G1853106)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
CAUTION:
- Make sure that the area around the component is clean and free of foreign material.
- Make sure the working surfaces are thoroughly clean to avoid contamination of the sensitive components.
- Make sure that the valve grinding paste is kept away from the valve stem.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Place a small amount of fine valve grinding paste evenly around the contact face of the valve.
Place the valve in position and, using a suitable valve grinding tool, rotate the valve back and forth a few degrees on its seat, using light pressure.
Raise the valve frequently during lapping and turn it into a new position after a few laps or rotations.
Lap only until a continuous but narrow lapping mark is visible on both the valve seat and valve face.
Thoroughly clean all surfaces to remove traces of valve grinding paste from the cylinder head, valve seat and valve face.
Repeat steps 5 to 8 for the remaining valves.