FLEXPLATE - Fwd (G1896064): Installation
WARNING: This page is about a different variant/trim than selected.
- CAUTION:
- Install all the bolts finger tight before final tightening.
- The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
- Install the bolts in the noted position.
NOTE:- Make sure the crankshaft and flexplate mating faces are clean before installation.
- Make sure that the crankshaft is not rotated.
- Tighten the retaining bolts working diagonally.
Special Tool(s): JLR-303-1304
Renew Part: Flywheel bolts Quantity: 1 .
- Refer to: TRANSMISSION - V6 S/C 3.0L PETROL