Right Camshaft (G1557012): Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Make sure that the orientation and code on the top of the camshaft bearing caps is noted (along with the bank - A or B), so that on installation the components are installed to their original position. Failure to follow this instruction may cause damage to the vehicle.
NOTE:
- Some illustrations may show the engine removed for clarity.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
- Refer to: TIMING DRIVE COMPONENTS (G1851002)
-
CAUTION:
- Rotate the camshafts until all the valves are at their minimum open point.
- Evenly and progressively, release the camshaft bearing caps.
NOTE: Remove the camshaft bearing caps.NOTE: Their position, orientation and markings. Each is marked with its position (number) and an orientation (arrow).