FLEXPLATE (G1850992): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some components shown removed for clarity.
- Refer to: TRANSMISSION - V6 S/C 3.0L PETROL .
-
CAUTION:
- The bolts can only be used 3 times, mark the bolts with a center punch. If 2 punch marks are visible, discard the bolts.
- Make sure that no components fall off during removal.
- Note the position of the bolts, prior to removal.
NOTE:- Make sure the crankshaft and flexplate mating faces are clean before installation.
- Make sure that the crankshaft is not rotated.
Install the special tool.
Special Tool(s): JLR-303-1304