Crankshaft Front Seal (G1850999): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING .
- Disconnect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .
- Remove the crankshaft pulley.
Refer to: CRANKSHAFT PULLEY (G1851000) .
Using the special tool remove and discard the front crankshaft oil seal.
Special Tool(s): 303-1434