LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine V6 S/C 3.0L Petrol -- XF/(X260) ( 1 Of 2)) >> Engine - V6 S/C 3.0L Petrol (G2289428) >> General Procedures >> Fuel Pump Camshaft Timing Adjustment (G1851630) >> Check

Fuel Pump Camshaft Timing Adjustment (G1851630): Check

WARNING: This page is about a different variant/trim than selected.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. Disconnect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

  2. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  3. Refer to: FUEL PUMP CAMSHAFT TIMING CHECK (G1851629) 
  4. Refer to: LOWER TIMING COVER (G2385449) 
  5. CAUTION:
    • Make sure that the area around the component is clean and free of foreign material.
    • Inspect the 3 timing chain oil nozzles for signs of damage, install as necessary.
    G11284882Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  6. CAUTION:
    • Using a suitable tie strap, position the tensioner to one side.
    • Take extra care when removing the component. Make sure the washers fitted both sides of the balance weight do not fall into the engine oil pan.
    G13970447Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Make sure the colored chain links align correctly with the fuel rail high-pressure fuel pumps camshaft, balance shaft and crankshaft sprocket markings.

    Special Tool(s): JLR-303-1621 

    Torque 

    Stage 1: 25 Nm 

    Stage 2: 90° 

  7. Refer to: LOWER TIMING COVER (G2385449) 
  8. G11285264Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the special tool.

    Special Tool(s): JLR-303-1303 

  9. G11285263Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Torque  : 10 Nm 

  10. NOTE: Install a new sealing washer.
    G11284854Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Renew Part: Oil pan drain plug  Quantity: 1  .

    Torque  : 24 Nm 

  11. Connect the battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT .

    • Fill the engine with the oil drained previously.
    • Clean any residual engine oil from the oil filler cap area.
  12. G11309561Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  13. CAUTION: Make sure that the vehicle has been left for 10 minutes from filling with oil, and that the engine oil level is reading at least minimum. Follow steps 17 - 23 before starting the engine.

    Start the engine and allow to run for 10 minutes, stop the engine.

  14. Refer to: ENGINE UNDERSHIELD .
  15. CAUTION:
    • Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
    • Make sure that the hood is open.

    Turn on the ignition.

  16. G11309562Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Press the menu button to access the main menu display.

  17. G11309563Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Scroll down the menu to the Vehicle Info selection.

  18. G11309564Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Press the menu button to access the Vehicle Info display.

  19. G11309565Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Scroll down the menu to the Oil Level selection.

  20. G11309566Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Press the menu button to access the Oil Level display.

  21. G11309567Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Press the cruise control cancel button 2 times to update the oil level value.

  22. G11309568Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Allow 10 minutes for the engine oil level to stabilize if there has been an additional oil top up. Repeat steps  16 -  24.

  23. Turn off the ignition.