Engine Oil Vacuum Draining And Filling (G1850998): Filling
WARNING: This page is about a different variant/trim than selected.
- NOTE:
- Install new O-ring seals.
- Lubricate the O-ring seals with clean engine oil.
Renew Part: Oil filter O-ring seal(s) Quantity: 1 .
Renew Part: Oil filter Quantity: 1 .
-
CAUTION: Tighten the component finger tight first.
Torque : 25 Nm
-
- Fill the engine with oil - for filling values on vehicles with supercharger:
Refer to: SPECIFICATION
- Clean any residual engine oil from the oil filler cap area.
- Fill the engine with oil - for filling values on vehicles with supercharger:
-
CAUTION: Make sure that the vehicle has been left for 10 minutes from filling with oil and that the engine oil level is reading at least minimum. Follow steps 10-16, before starting the engine.
-
- Start the engine and allow to run for 10 minutes, stop the engine.
- Check for leaks.
- Allow 10 minutes for the engine oil level to stabilize.
-
CAUTION:
- Make sure that the selector lever and the gearshift mechanism are in the park (P) position.
- Make sure that the hood is open.
- Turn on the ignition.
- Press the menu button to access the main menu display.
Scroll down the menu to the Vehicle Info selection.
Press the menu button to access the Vehicle Info display.
Scroll down the menu to the Oil level selection.
- Press the menu button to access the Oil level display.
- If the engine oil level is not available, it will be necessary to update the oil level value.
- Press the cruise control cancel button 2 times to update the Oil level value.
- Check that the oil level display shows an oil level reading.
- If necessary top up with engine oil.
- Allow 10 minutes for the engine oil level to stabilize if there has been additional oil top up. Repeat steps 9-17.
- Make sure that the average oil level value has now been updated.
- Turn off the ignition.
- Refer to: ENGINE COVER - V6 S/C 3.0L PETROL .