Manifold Absolute Pressure Sensor (G1818381): Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Removal steps in this procedure may contain installation details.
- Some variation in the illustrations may occur, but the essential information is always correct.
- Refer to: SECONDARY BULKHEAD LEFT PANEL - V6 S/C 3.0L PETROL
Torque : 10 Nm
Torque : 10 Nm
Torque : 10 Nm
Reposition and secure the wiring harness.
Use a suitable small ratchet to access the bolt.
-
CAUTION:
- Take extra care not to drop the bolt.
- Make sure that the sensor is removed straight back, as this prevents the O-ring seal catching on the housing.
Torque : 5 Nm