Coolant Pump (G1824662): Removal

WARNING: This page is about a different variant/trim than selected.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
Drain the coolant system.
Refer to: COOLING SYSTEM DRAINING AND VACUUM FILLING
Remove the accessory drive belt.
Refer to: ACCESSORY DRIVE BELT (G1820724)
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Using a suitable tool remove the coolant hose.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the thermostat bolt.
CAUTION: Be prepared to collect escaping coolant.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Release the clip and the coolant hose from the coolant pump.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the accessory drive belt tensioner.
WARNING: Fluid loss is unavoidable, use absorbent cloth or a container to collect the fluid.

CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.

Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Remove the coolant pump and discard the seals.

Torque : 12 Nm