Cooling System Draining And Vacuum Filling (G1822256): Draining
WARNING: This page is about a different variant/trim than selected.
WARNING:
Injury such as scalding could be caused by escaping steam or coolant. Make sure the vehicle cooling system is cool prior to carrying out this procedure.
CAUTION:
- The engine cooling system must be maintained with the correct concentration and type of engine coolant to prevent corrosion and frost damage. Failure to follow this instruction may result in damage to the engine.
- Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
- Never remove the coolant expansion tank cap under any circumstances while the engine is operating. Failure to follow this instruction may result in damage to the engine.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: LIFTING
-
WARNING: Release the cooling system pressure by slowly turning the coolant expansion tank cap a quarter of a turn. Cover the coolant expansion tank cap with a thick cloth to prevent the possibility of scalding. Failure to follow this instruction may result in personal injury.CAUTION: Be prepared to collect escaping coolant.
Remove the coolant expansion tank cap.
- Remove the engine undershield
Refer to: ENGINE UNDERSHIELD
- Position a container to collect the fluid.
-
NOTE: Be prepared to collect escaping coolant.
Remove the radiator drain plug and allow the coolant to drain into a suitable container.
Install the radiator drain plug.
Torque : 3.5 Nm