Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

- Install the fuel filler pipe.
- Install the 3 retaining nuts.
  Torque Specification: 10 Nm
- Secure the 2 retaining clips to the fuel filler pipe.
- Secure the clamp to the fuel filler pipe.
Secure the fuel pipe to the fuel filler pipe.
- Secure the breather hose to the 5 retaining clips.
- Install the rear right wheel arch liner.
- Install the 8 retaining clips and 2 retaining screws.
Install the wheel and tire assembly.
Refer to: Wheel and Tire .
Fill the fuel system.
Connect the startup battery ground cable.
Refer to: Battery Disconnect and Connect .