Wire Chart and Service Repair Information

This information is part of the relevant Electrical Reference Library (ERL) or Interactive Electrical Wiring Diagrams (iEWD) available through TOPIx.

Once the relevant connector housing has been identified, refer to the associated Wire Chart and Service Repair Information to make sure the installation of pre-terminated leads or wiring harnesses are completed in the approved manner.

• Identify the connector cavity in which the terminal needs replacing
• Make a note of the cross sectional area of the associated wire
• Make a note of the part number of the appropriate pre-terminated lead
• Make a note of the correct terminal extraction tool (where applicable)

Before commencing a wiring harness repair, always make sure the correct pre-terminated leads and associated repair parts have been ordered using the Jaguar/Land Rover parts ordering system.

Some of the pre-terminated leads have seals installed to the insulation for sealed connector applications. Where, as part of a repair, sealed terminals are removed, it is essential that those terminals are replaced by sealed pre-terminated leads.

Wire Chart And Service Repair Information Also Includes: 

• The destination of the cable
• The applicable tools and associated other parts necessary to make sure the pre-terminated lead is correctly installed in the approved manner