Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Care must be taken when refitting the valve body assembly.

NOTE: Make sure that the component is installed to the noted removal position.

Install the valve body and secure the linkage.
NOTE: Tighten the retaining bolts evenly and progressively.

Fig 1: Valve Body Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the valve body bolts in the sequence shown in illustration.

Torque Specification: 8 Nm
Using the special tool, turn the electrical connector 90 degrees anti clockwise to install.

Special Tool(s): JLR-308-844
Remove the special tool.
Make sure that the electrical connector is installed in the correct orientation as noted in the removal step.
Secure the electrical connector retaining clip.
CAUTION: Make sure that the electrical connector is correctly fitted.

Connect the transmission electrical connector.
Install the electrical harness bolt.

Torque Specification: 8 Nm
CAUTION: Make sure all suitable safety precautions are taken to protect the Transmission Control Module (TCM) and main control valve body electrical connector pins against electrostatic discharge.

Install the valve body bracket bolts.

Torque Specification: 8 Nm
Install the oil accumulator.
NOTE: Tighten the retaining bolts evenly and progressively.

Fig 2: Oil Accumulator Retaining Bolts Tightening Sequence
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Install the 3 oil accumulator retaining bolts.

Torque Specification: 8 Nm
Connect the oil accumulator electrical connector.
Install the transmission fluid pan.
Refer to: Transmission Fluid Pan, Gasket and Filter .
Using the approved diagnostic tool, calibrate the main control valve body and the Transmission Control Module (TCM).