Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:
- Make sure that the mating faces are clean and free of foreign material.
- Install a new seal.
- Using the special tool, install the extension housing seal. Renew Part: Extension housing seal Quantity: 1. Refer to Part(s) .
- Special Tool(s): 307-520
- Special Tool(s): JLR-307-520-01
Install the output flange.

Renew Part: Transmission output shaft flange Quantity: 1. Refer to Part(s) .
WARNING: Make sure that a new nut is installed.
- Using the special tool, install the transmission output flange retaining nut. Renew Part: Output shaft flange nut Quantity: 1. Refer to Part(s) .
- Torque Specification: 60 Nm
- Special Tool(s): 205-053
Torque Specification: 48 Nm
CAUTION: Care must be taken not to damage the component.
- Secure with a cable tie.
CAUTION: Make sure that new bolts are installed.

Install the driveshaft. Renew Part: Driveshaft to front output flange bolts Quantity: 6. Refer to Part(s) .

Torque Specification: 75 Nm
- Remove the cable tie.
Install the selector cable.

Torque Specification: 11 Nm
Refer to: TRANSMISSION SUPPORT INSULATOR (G1818209) (Removal and Installation).
Connect the startup battery ground cable. refer to