LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (Climate Control -- XE (X760)) >> Climate Control >> Condenser - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the condenser and secure the side clip.
  2. Install the 3 mounting brackets.

    Torque Specification: 10 Nm 

  3. Install the lower mounting bracket.

    Torque Specification: 10 Nm 

  4. Install the lower air deflector trim.
  5. Install new O-ring seals and connect the refrigerant lines.

    Renew Part: Air conditioning pipe to condenser O-ring seal. 

    Torque Specification: 20 Nm 

  6. Install the active radiator vanes.

    Torque Specification: 9 Nm 

  7. Install the adaptive speed control module mounting bracket.

    Torque Specification: 9 Nm 

  8. Connect the 2 electrical connectors.
  9. Install the 2 upper air deflector trims.

    Torque Specification: 9 Nm 

  10. Install the front bumper.

    Refer to: Front Bumper .

  11. Charge the air conditioning system.

    Refer to: Air Conditioning System Recovery, Evacuation and Charging (General Procedures).

scientia non olet · About LEMON Manuals