Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Raise and support the vehicle on a suitable 2 post lift.
Refer to: Lifting .
- Recover the refrigerant.
Refer to: Air Conditioning System Recovery, Evacuation and Charging (General Procedures).
- Remove the charge air radiator.
Refer to: CHARGE AIR COOLER .
Remove the 2 clips.
Remove the 3 clips.
Remove the 2 nuts.
Remove the charge air radiator bracket.
- Remove the accessory drive belt.
Refer to: Accessory Drive Belt .
-
CAUTION:
- Make sure that all openings are sealed. Use new blanking caps.
- Remove and discard the O-ring seals.
- Remove the clip.
- Remove the 2 nuts.
- Remove and discard the O-ring seals.
Disconnect the electrical connector.
- Remove the 3 bolts.
- Remove the A/C compressor.