Removal And Installation: Installation
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Install the A/C compressor.
Torque Specification: 25 Nm
- Connect the electrical connector and the clip.
-
NOTE:
- Install new O-ring seals.
- Remove and discard the blanking caps.
- Install the new O-ring seals.
Renew Part: Air conditioning pipe to compressor O-ring seals.
- Install the 2 nuts.
Torque Specification: 9 Nm
- Install the clip.
- Install the accessory drive belt.
Refer to: Accessory Drive Belt .
- Install the charge air radiator bracket.
Torque Specification: 47 Nm
- Install the 2 nuts.
Torque Specification: 10 Nm
- Install the 3 clips.
- Install the charge air radiator.
Refer to: Charge Air Cooler .
- Charge the A/C system.
Refer to: Air Conditioning System Recovery, Evacuation and Charging (General Procedures).