Pinpoint Test H: Bolster Deflate Tests

TEST CONDITIONS 

DETAILS/RESULTS/ACTIONS 

1. H1: BOLSTER DEFLATE TEST 1 
   NOTE:

   • Circuit reference - VBATT -
   • The bolster deflate circuit current specification is 0.50A ± 10%.
   1. Connect an inductive ammeter to the seat switchpack power circuit
   2. Set the ignition to on
   3. Operate the seat switchpack bolster deflate switch

   Is the measured current less than specification?

   • Yes  : GO to H2.
   • No  : Check the bolster air cell hoses for blockages
2. H2: BOLSTER DEFLATE TEST 2 
   NOTE: Do not disconnect the electrical connector during this step; the seat switchpack is removed for access to the wiring harness only.
   1. Refer to the relevant section of the service information and remove the seat switchpack
   2. Set a multimeter to measure voltage
   3. Using the multimeter, measure and record the battery voltage (reference voltage)
      NOTE: Circuit reference - BOLSTER DEF/GND -
   4. Connect the multimeter across the seat switchpack bolster deflate terminal and the ground terminal
   5. Set the ignition to on
   6. Operate the seat switchpack bolster deflate switch

   Is the measured voltage less than battery voltage?

   • Yes  : GO to Pinpoint Test A .
   • No  : Refer to the applicable System Wiring Diagram(s) and check the bolster deflate circuit for short circuit to ground, short circuit to power, open circuit, high resistance
     NOTE: Some DTCs can only be set if the fault is detected during the On Demand Self Test routine.
     NOTE: The battery support unit must be connected during this test to ensure that the power supply is stable.