Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Removal steps in this procedure may contain installation details.
Some variation in the illustrations may occur, but the essential information is always correct.
LH illustration shown, RH is similar.

Remove and discard the rear seat cushion retaining clips.

Make sure new clips are fitted.

Renew Part: Retaining clips Quantity: 4.
- Disconnect the electrical connectors.
- Remove the seat base.
Remove the door aperture seal.
Remove the treadplate.
Remove the rear seat bolster.