Visual Inspection
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern
- Confirm if the ABS warning light was illuminated, or still isNOTE: An intermittent fault may allow the warning light to go off. This does not necessarily mean the fault is not present. Some warnings will appear to clear when the ignition is cycled. This is often because the warning has flagged as a result of one of the vehicle's on-board diagnostic routines having run to detect the fault. If the same routine is not run when the ignition status is set to ON , the warning will not re-flag until the routine does run
- Visually inspect for obvious signs of damage and system integrity
MECHANICAL ELECTRICAL - Brake fluid level
- Vacuum system
- Wheel speed sensor installation
- Wheel speed sensor air gap
- Magnetic pulse wheel(s) (damaged/contaminated)
- Steering angle sensor
- Yaw rate lateral acceleration sensor
- Incorrect wheel or tire size
- Warning light operation
- Fuses
- Wheel speed sensors
- Connectors/Pins
- Harnesses
- Steering wheel rotation sensor
- Yaw rate lateral acceleration
- sensor
- Booster pressure sensor
- Hydraulic control unit
- If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step
- If the cause is not visually evident check for Diagnostic Trouble Codes (DTCs) and refer to the DTC Index