Check / Adjustment
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
This procedure details how to adjust the speed control sensor vertically. There is no horizontal adjustment required.
- Raise and support the vehicle.WARNING: Make sure to support the vehicle with axle stands.
- Refer to: Front Bumper .
-
NOTE: Make sure that the vehicle is standing on a level surface.
- Using the special tool, check the speed control sensor is level, (+/- 0.5 degree).
Special Tool(s): 501-F007
ADJUSTMENT
Special Tool(s): 501-F007
- Refer to: Front Bumper .
-
- This procedure is required if:
- The ACC radar needed to be removed or is misaligned in its position due to another repair operation.
-
- From the diagnostic tool menu, select: Service Alignment Mode.
- The follow indicator will now be flashing, this indicates that the vehicle is in "service alignment" and now requires driving.
- The vehicle speed must be above 30 mph (48 kph).
- Choose a road with plenty of stationary objects, like street lights, road signs, or barriers. Use an inside or outside lane.
- Following vehicles too closely will obscure the stationary targets from the radar, a time gap of 2 seconds is recommended.
- A straight road will produce a quicker and better result, although the process will still operate on a curved road.
- The time that the ACC module takes to align will vary, depending on the route, speed, number of targets, and individual module.
- When the flashing follow indicator light extinguishes, the ACC system is now functional, and a required vehicle speed can now be set by the driver and the ACC system will operate as normal.