LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Engine - V6 S/C 3.0L Petrol -- XE (X760)) >> Engine - V6 S/C 3.0L Petrol >> Crankshaft Front Seal >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Disconnect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

  3. Remove the crankshaft pulley.

    Refer to: Crankshaft Pulley .

  4. G11284907

    Using the special tool remove the front crankshaft oil seal.

    Special Tool(s):  303-1434

scientia non olet · About LEMON Manuals