LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Rear Drive HALFSHAFTS -- XE (X760)) >> Rear Drive HALFSHAFTS >> Rear HALFSHAFT - INGENIUM I4 2.0L Diesel (G1817243) >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure new circlip is installed
    G11305907

    Renew Part: Circlip Quantity: 1.

  2. Make sure the snap ring is fully engaged and retains the halfshaft.
    CAUTION: Keep the halfshaft horizontal to avoid damaging the oil seal.
    G11305908
  3. To install, reverse the removal procedure.
  4. Install the wheel and tire.

    Refer to: Wheel and Tire .

  5. Check and adjust the differential oil.

    Refer to: Differential Draining and Filling - INGENIUM I4 2.0L Diesel .

  6. Check, and if necessary, adjust the wheel alignment.
scientia non olet · About LEMON Manuals