Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
This procedure contains illustrations showing certain components removed to provide extra clarity.

Raise and support the vehicle on a suitable 2 post lift. Refer to: Lifting .
Drain the front differential.
Refer to: Differential Draining and Filling .
Remove the front driveshaft.
Refer to: Front Driveshaft - AWD .
Using a suitable tool, remove the pinion sleeve.
Using a center punch and hammer, pierce a hole in the seal at the 12 O'clock position.
Screw a 2.5 x 15 mm self-tapping screw, a maximum of 2 turns into the input shaft seal and remove the seal using a pair of pliers.
WARNING: Be prepared to collect escaping oil.