LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Power Brake Actuation -- XE (X760)) >> Power Brake Actuation >> Brake Vacuum Pump - INGENIUM I4 2.0L Petrol (G2046495) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustration depending on the vehicle specification, but essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

    General Equipment: Two-post lift 

  2. Disconnect the battery ground cable.

    Refer to: Battery Disconnect and Connect .

  3. Remove the oil pump chain.

    Refer to: Oil Pump Chain (G1867695) .

  4. Disconnect the oil pump solenoid electrical connector.
    G11308715
  5. Release the oil pump solenoid wiring harness from the 4 retaining clips.
    G11308716
  6. CAUTION: Discard the vacuum pump seals.
    G11308717
    • Remove the 4 bolts securing the vacuum pump to the engine assembly.
    • Remove the vacuum pump assembly and discard the vacuum pump seals.
  7. CAUTION: Discard the oil pick up pipe seal.
    NOTE: Do not disassemble further if the component is removed for access only.
    G11308718
scientia non olet · About LEMON Manuals