Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Only carry out this step if previously removed.
- Install the oil pick up pipe onto the vacuum pump assembly and make sure a new O-ring seal is fitted.
  Renew Part: Oil pick up pipe O-ring seal.
- Install and tighten the 2 bolts securing the oil pick up pipe to the vacuum pump assembly.
  Torque Specification: 12 Nm
- Install the vacuum pump assembly and make sure new vacuum pump O-ring seals are fitted.
  Renew Part: Brake vacuum pump O-ring seal.
- Install and tighten the 4 bolts securing the vacuum pump to the engine assembly.
  Torque Specification: 25 Nm
Install the oil pump solenoid wiring harness and secure in position with the 4 retaining clips.
Connect the oil pump solenoid electrical connector.
Install the oil pump chain.
Refer to: Oil Pump Chain (G1867695) .
Lower the vehicle.
Connect the battery ground cable.
Refer to: Battery Disconnect and Connect .