LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Front Disc Brake -- XE (X760)) >> Front Disc Brake - INGENIUM I4 2.0L Diesel >> Brake Pads - V6 S/C 3.0L Petrol (G1822045) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Brake pads must be renewed in axle sets only. Failure to follow this instruction may result in braking efficiency being impaired.
  • If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
  1. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  2. Remove the front wheels and tires. Refer to: Wheel and Tire .
  3. NOTE: If equipped.
    G11308607
  4. G11308608
  5. Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
    CAUTION: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
    G11308609
  6. Tie aside.
    CAUTION: Do not allow the brake caliper to hang on the brake hose.
    G11308635
  7. G11308636
scientia non olet · About LEMON Manuals