Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.

CAUTION: If brake fluid is spills on the paint work, the affected area must be immediately washed down with cold water.

NOTE: Make sure that all openings are sealed.

Raise and support the vehicle.
WARNING: Make sure to support the vehicle with axle stands.
Remove the wheel and tire.
Refer to: Wheel and Tire .
Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
Remove the flexible brake hose.
CAUTION:
- Inspect the brake hose sealing washers for signs of damage, if damage is present discard the sealing washers.
- Be prepared to collect escaping fluids.
NOTE: Make sure that all openings are sealed.