Programming HOMELINK® Universal Transmitter

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: It is recommended that a new battery be placed in the hand-held transmitter of the device being programmed to HomeLink® for quicker training and accurate transmission of the Radio Frequency (RF) signal.

Step 1

Turn the ignition On.

Step 2

Press and hold the outer two switches of the HomeLink® universal transmitter until the status indicator begins to flash.

Step 3

Release the switches.

This initializes the HomeLink® universal transmitter and erases previous settings from all three channels.

Step 4

Place the signal emitting end of the hand held transmitter 2 - 8 cm (1 - 3 inches) away against the underside of the rear view mirror. Keep the status indicator in view.

Simultaneously press and hold the activation switch on the hand held transmitter and the chosen switch of the HomeLink® universal transmitter. The status indicator begins to flash slowly.

NOTE: Do not release the buttons until the following step has been completed.

Step 5

The status indicator begins to flash rapidly. This can take up to 60 seconds.

Step 6

Release both switches.

Step 7

Press the programmed HomeLink® universal transmitter switch. The solid status indicator light indicates the successful programming.

To program another channel on the HomeLink® universal transmitter, repeat Steps 4 to 7.

Step 8

Turn the ignition Off.

To operate the previously programmed device, press and hold the chosen switch of the HomeLink® universal transmitter. Release the switch when the device begins to operate.