Removal And Installation: Removal
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe due care when working near a hot exhaust system.
CAUTION:
Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
NOTE:
- This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
- This procedure contains illustrations showing certain components removed to provide extra clarity.
- Remove the engine cover.
Refer to: Engine Cover - INGENIUM I4 2.0L Diesel .
- Disconnect and release the post Diesel Particulate Filter (DPF) exhaust gas temperature sensor wiring harness.
- Remove the post DPF exhaust gas temperature sensor.