LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Front End Body Panels) >> Front End Body Panels >> Secondary Bulkhead Left Panel - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the secondary bulkhead left panel.
    • Install and tighten the 3 bolts.

      Torque Specification: 5.4 Nm 

  2. Connect the brake booster vacuum hose quick release connector.
    • Install the engine compartment brace.
    • Install and tighten the 4 bolts.

      Torque Specification: 55 Nm 

  4. Install the secondary bulkhead right panel.

    Refer to: Secondary Bulkhead Right Panel - INGENIUM I4 2.0L Petrol .

  5. Connect the startup battery ground cable.

    Refer to: Battery Disconnect and Connect .

scientia non olet · About LEMON Manuals