Pinpoint Test G: D-Loop Not Rotating Correctly
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- G1: D-LOOP NOT ROTATING CORRECTLY
- Refer to the appropriate service information for removal and installation, remove any trim panels required to expose the D loop (anchor point) and the seatbelt retractor
- Ensure there are no obstructions and the webbing does not catch or rub, the D loop (anchor point) rotates correctly
- Check for correct operation twice
Does the webbing move freely then retract correctly?
- Yes : Refer to the appropriate service information for removal and installation, reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required
- No : Replace as required. Refer to the warranty policy and procedures manual, or determine if any prior approval program is in operation, prior to the installation of a new module/component