Pinpoint Test C: SEATBELT Retractor-Webbing Guide Loose
WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
- C1: SEATBELT RETRACTOR-WEBBING GUIDE LOOSE
- Refer to appropriate service information for removal and installation, remove any trim panels required to expose the D loop (anchor point) and seatbelt retractor
- Check the webbing is not trapped or twisted and is centrally located on the seatbelt retractor spindle
- Attempt to withdraw the webbing from the seatbelt retractorNOTE: If the seatbelt webbing is jammed, the automatic locking retractor could be engaged
- To release the automatic locking retractor, manually wind the webbing onto the spindle until the automatic locking retractor deactivates (clicking stops)
- Fully extract webbing
- Confirm webbing guide location is correct, Confirm the fixing lugs are correctly located in the retractor frame
- Allow webbing to retract
- Check for correct operation twice
Does the webbing move freely then retract correctly?
- Yes : Refer to the appropriate service information for removal and installation, reinstall any trim panels, ensure there are no obstructions and the webbing does not catch or rub. No further action required
- No : GO to Pinpoint Test D .