Electric Park Brake Actuator (G1822087): Removal
WARNING: This page is about a different car, the 2020 Jaguar XE and 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Removal steps in this procedure may contain installation details.
- Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
-
NOTE: This step is only required if the diagnostic tool is not available.
Refer to: ELECTRIC PARK BRAKE SERVICE MODE ACTIVATION AND DEACTIVATION
-
WARNING: Make sure to support the vehicle with axle stands.
Raise and support the vehicle.
-
NOTE: Remove and discard the O-ring seal.
Renew Part: Electric park brake actuator O-ring seal Quantity: 1.
Torque : 8Nm