LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Wheels & Tires -- XE (X760)) >> Wheels And Tires >> Tire Pressure Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the washer and seal, making sure the valve remains pressed fully onto its seat.
    CAUTION:
    • Make sure that the seal is correctly located.
    • Make sure that new components are installed.
    G11305668
  2. WARNING:
    • Make sure that any corrosion or dirt is removed from the mating surfaces.
    • Make sure that a new tire valve, valve core, seal, washer, cap and retaining nut is installed.
    CAUTION:
    • Use lint free cloth.
    • Only use moderate force when installing the sensor.
    NOTE: Only tighten the nut finger tight at this stage.
    G11305669

    Torque Specification: 8 Nm 

  3. Install the tire and balance the wheel.
  4. Refer to: Wheel and Tire .
  5. If a new component has been installed, configure using Jaguar approved diagnostic equipment.
scientia non olet · About LEMON Manuals