LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Rear Disc Brake -- XE (X760)) >> Rear Disc Brake - V6 S/C 3.0L Petrol/INGENIUM I4 2.0L Diesel >> Brake Pads (G1822059) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Brake pads must be renewed in axle sets only, otherwise braking efficiency may be impaired.
  • If the brake pad wear warning light has been activated, a new brake pad wear sensor must be installed.
NOTE: Removal steps in this procedure may contain installation details.
  1. Connect the diagnostic tool and set the electronic park brake (EPB) to the maintenance position.
  2. NOTE: This step is only required if the diagnostic tool is not available.

    Refer to: Electronic Parking Brake (EPB) Service Mode Activation and Deactivation .

  3. NOTE: This step is only required if the vehicle has no battery power.

    Refer to: Electronic Parking Brake (EPB) Release When the Vehicle Has No Electrical Power .

  4. Raise and support the vehicle.
    WARNING: Make sure to support the vehicle with axle stands.
  5. Refer to: Wheel and Tire .
  6. G11305894
  7. Inspect the brake pad wear sensor for signs of wear or damage. Install a new sensor if necessary.
    NOTE: The brake pad wear indicator sensor is easily damaged. Do not use a lever to remove the sensor. Use fingers only.
    G11305896

    Torque Specification: 28 Nm 

  8. G11308669
scientia non olet · About LEMON Manuals