LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Bumpers) >> Bumpers >> Front Armature (G1818677) >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal steps in this procedure may contain installation details.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. NOTE: Repeat the procedure for the other side.

    Refer to: Headlamp Assembly .

  3. NOTE: Repeat the step for the other side.
    G11312364
  4. NOTE: Repeat the step for the other side.
    G11312365
  5. CAUTION: Take extra care not to damage the component.
    G11312366
  6. G11312367

    Torque Specification: 9 Nm 

  7. G11312368

    Torque Specification: 25 Nm 

  8. G11312369

    Torque Specification: 25 Nm 

  9. G11312370

    Torque Specification: 7 Nm 

  10. NOTE:
    • Repeat the step for the other side.
    • Make sure that new bolts are installed.
    G11312371

    Torque Specification: 110 Nm 

  11. NOTE: Make sure that new bolts are installed.
    G11312372

    Torque Specification: 

    Stage 1: 100 Nm 

    Stage 2: 180° 

  12. NOTE: Make sure that new bolts are installed.
    G11312373

    Torque Specification: 110 Nm 

  13. CAUTION: Take extra care not to damage the component.
    G11312374

    Torque Specification: 10 Nm 

  14. NOTE:
    • Fuel fired booster heater (FFBH) shown removed for clarity.
    • Make sure that new bolts are installed.
    G11312375

    Torque Specification: 110 Nm 

  15. NOTE: Make sure that new bolts are installed.
    G11312376

    Torque Specification: 110 Nm 

scientia non olet · About LEMON Manuals