LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Fuel System - General Information -- XE (X760)) >> Fuel System - General Information >> Fuel System Bleeding (G1801385) >> General Procedures

General Procedures

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
19.50.08 FUEL SYSTEM BLEED - LOW PRESSURE SIDE 2000 CC, INGENIUM DIESEL 0.1
WARNING: After carrying out repairs, the fuel system must be checked visually for leaks. Failure to follow this instruction may result in personal injury.
NOTE: This procedure is necessary if any low-pressure fuel system components are removed or replaced. These include the fuel filter, fuel lines, fuel tank or fuel cooler.
  1. CAUTION: Do not start the engine.
    1. Set the ignition to the ON position.
    2. Wait for 65 seconds.
    3. Set the ignition to the OFF position.
    4. Repeat the above steps 2 more times.
  2. Start the engine and idle for 60 seconds