LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Post Catalyst Heated Oxygen Sensor - AWD >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION:
    • Make sure the anti-seize compound does not contact the HO2S tip.
    • If accidentally dropped or knocked install a new sensor.
    • Make sure the HO2S wiring harness is not twisted more than 180 degrees and is not in contact with either the exhaust or driveshaft.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.

    To install, reverse the removal procedure.

scientia non olet · About LEMON Manuals