LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Fuel Rail Pressure Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.
  • Make sure that the tools and equipment are clean, free of foreign material and lubricant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Always follow the fuel system health and safety precautions, when carrying out any repairs to the fuel system. Refer to:

    Refer to: Petrol and Petrol-Ethanol Fuel Systems Health and Safety Precautions .

  2. Release the fuel system pressure.

    Refer to: Fuel System Pressure Release (General Procedures).

  3. Disconnect the start up battery ground cable.

    Refer to: Battery Disconnect and Connect (General Procedures).

  4. Remove the engine cover.

    Refer to: Engine Cover - V6 S/C 3.0L Petrol (Removal and Installation).

  5. Remove the cowl panel.

    Refer to: Cowl Vent Screen (Removal and Installation).

  6. G11308512

    Remove the pipe and engine NVH cover.

  7. Clean the fuel injection components. Refer to: Fuel Injection Component Cleaning (General Procedures).
  8. G11308513

    Diconnect the electrical connector.

  9. CAUTION: Be prepared to collect escaping fluids.
    G11293308
scientia non olet · About LEMON Manuals