LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Electronic Engine Controls - V6 S/C 3.0L Petrol -- XE (X760)) >> Electronic Engine Controls - V6 S/C 3.0 L Petrol >> Engine Coolant Temperature Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Jaguar XE and 2017 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: Lifting .

  2. Remove the engine cover.

    Refer to: Engine Cover - V6 S/C 3.0L Petrol .

  3. Drain the coolant system.

    Refer to: Cooling System Draining and Vacuum Filling (General Procedures).

  4. Remove the secondary bulkhead panel right.

    Refer to: Secondary Bulkhead Right Panel - V6 S/C 3.0L Petrol .

  5. WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the engine coolant temperature sensor while the system is hot.
    CAUTION: Be prepared to collect escaping coolant.
    G11308490

    Disconnect the electrical connector and remove the engine coolant temperature sensor.

scientia non olet · About LEMON Manuals