LEMON Manuals: Even more car manuals for everyone
Home >> Jaguar >> 2020 >> XF Checkered Flag >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Engine - V6 S/C 3.0L Petrol -- XE/(760)) >> Engine - V6 S/C 3.0L Petrol (G2289428) >> Removal And Installation >> Crankshaft Rear Seal(G1557015) >> Removal

Crankshaft Rear Seal(G1557015): Removal

WARNING: This page is about a different car, the 2019 Jaguar XE. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift. Refer to: LIFTING
  2. Disconnect the startup battery ground cable. Refer to: STARTUP BATTERY DISCONNECT AND CONNECT
  3. Remove the flexplate.

    Refer to: FLEXPLATE 

  4. G11285382Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove and discard the crankshaft rear oil seal plate.

scientia non olet · About LEMON Manuals